A REVIEW OF OBSERVER-BASED FAULT DETECTION AND ISOLATION FOR MECHATRONIC SYSTEMS

Authors

  • Shohjakhon Jonuzokov University of Birmingham BEng Mechatronic and Robotic Engineering, Year Three Author

Keywords:

fault detection and isolation, observer-based diagnosis, analytical redundancy, unknown input observer, residual generation, mechatronic systems.

Abstract

Observer-based fault detection and isolation (FDI) exploits the analytical redundancy in a dynamic model of a plant to detect faults without additional hardware, generating a residual that departs from zero only when a fault occurs. This review consolidates the observer-based FDI literature for mechatronic systems, analysing methods within a single state-space fault model to enable direct comparison across notations. The fault detection filter, diagnostic observer, Kalman innovation filter and parity space method are shown to be alternative parameterisations of one residual generator. The central difficulty is the conflict between fault sensitivity and robustness to disturbance and model uncertainty: exact decoupling via unknown input observers is bounded by a rank condition on the sensor set, while approximate decoupling trades that guarantee for generality. An analytical case study on a two-mass servo drive shows that a single rank test determines what any design can achieve. Validation practice remains the field's weakest point.

References

1.Beard, R.V. (1971) Failure Accommodation in Linear Systems through Self-Reorganization. PhD thesis, MIT.

2.Blanke, M., Kinnaert, M., Lunze, J. and Staroswiecki, M. (2016) Diagnosis and Fault-Tolerant Control. 3rd edn. Springer.

3.Chen, J. and Patton, R.J. (1999) Robust Model-Based Fault Diagnosis for Dynamic Systems. Kluwer.

4.Chow, E.Y. and Willsky, A.S. (1984) ‘Analytical redundancy and the design of robust failure detection systems’, IEEE Transactions on Automatic Control, 29(7).

5.Darouach, M., Zasadzinski, M. and Xu, S.J. (1994) ‘Full-order observers for linear systems with unknown inputs’, IEEE Transactions on Automatic Control, 39(3).

6.Ding, S.X. (2013) Model-Based Fault Diagnosis Techniques. 2nd edn. Springer.

7.Edwards, C., Spurgeon, S.K. and Patton, R.J. (2000) ‘Sliding mode observers for fault detection and isolation’, Automatica, 36(4).

8.Frank, P.M. (1990) ‘Fault diagnosis in dynamic systems using analytical and knowledge-based redundancy’, Automatica, 26(3).

9.Gao, Z., Cecati, C. and Ding, S.X. (2015) ‘A survey of fault diagnosis and fault-tolerant techniques’, IEEE Transactions on Industrial Electronics, 62(6).

10.Gertler, J. (1998) Fault Detection and Diagnosis in Engineering Systems. Marcel Dekker.

11.Isermann, R. (2006) Fault-Diagnosis Systems. Springer.

12.Jones, H.L. (1973) Failure Detection in Linear Systems. PhD thesis, MIT.

13.Massoumnia, M.A. (1986) ‘A geometric approach to the synthesis of failure detection filters’, IEEE Transactions on Automatic Control, 31(9).

14.Patton, R.J. and Chen, J. (1991) ‘Robust fault detection using eigenstructure assignment’, Proc. IFAC/IMACS Symposium SAFEPROCESS.

15.Rajamani, R. (1998) ‘Observers for Lipschitz nonlinear systems’, IEEE Transactions on Automatic Control, 43(3).

16.Willsky, A.S. and Jones, H.L. (1976) ‘A generalized likelihood ratio approach to the detection and estimation of jumps in linear systems’, IEEE Transactions on Automatic Control, 21(1).

Downloads

Published

2026-09-07