THE EFFECT OF TECHNOLOGICAL PARAMETERS ON ADHESION STRENGTH IN THE PRODUCTION OF POLYMER COMPOSITE COATINGS FOR MECHANICAL ENGINEERING

Authors

  • Nazirov Bobur Ikromjon o‘g‘li, Z.U.Maxammadjonov Andijan State Technical Institute Associate Professor, Department of Automotive Engineering and Transport, Doctor of Philosophy (PhD) in Technical Sciences, Associate Professor Author

Keywords:

mechanical engineering, polymer composite coating, adhesion strength, technological parameters, surface preparation, curing process, wear resistance.

Abstract

This article examines the influence of technological parameters on the adhesion strength of polymer composite coatings used in mechanical engineering. The main properties of these coatings and the factors that ensure strong bonding with metal surfaces are analyzed. Particular attention is paid to the effects of surface preparation quality, temperature, curing time, and composite composition on coating performance. The proper selection of these parameters is essential for improving coating adhesion and reducing the risk of detachment. Furthermore, the possibilities of enhancing wear resistance and extending the service life of coatings through the optimization of technological processes are discussed. The findings of this article contribute to the improvement of technologies for producing effective polymer composite coatings to protect mechanical engineering components.

 

References

1.Liu J., Xue Y., Dong X., Fan Y., Hao H., Wang X. Review of the surface treatment process for the adhesive matrix of composite materials // International Journal of Adhesion and Adhesives. — 2023. — Vol. 126. https://doi.org/10.1016/j.ijadhadh.2023.103446

2.Primc G., Mozetič M. Surface Modification of Polymers by Plasma Treatment for Appropriate Adhesion of Coatings // Materials. — 2024. — Vol. 17, No. 7. — Article 1494. https://doi.org/10.3390/ma17071494

3.Liu J., Xue Y., Dong X., Fan Y., Hao H., Wang X. Review of the surface treatment process for the adhesive matrix of composite materials // International Journal of Adhesion and Adhesives. — 2023. — Vol. 126. https://doi.org/10.1016/j.ijadhadh.2023.103446

4.Primc G., Mozetič M. Surface Modification of Polymers by Plasma Treatment for Appropriate Adhesion of Coatings // Materials. — 2024. — Vol. 17, No. 7. https://doi.org/10.3390/ma17071494

5.ASTM International. ASTM D4541-22: Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers. — 2022. https://store.astm.org/standards/d4541

6.International Organization for Standardization. ISO 4624:2023: Paints and varnishes — Pull-off test for adhesion. — 2023. https://store.astm.org/standards/d4541

Downloads

Published

2026-10-13