STUDY OF THE ERGONOMIC CHARACTERISTICS OF SPECIAL-PURPOSE CLOTHING
Keywords:
garment fit, mobility restriction, pressure distribution, protective apparel, thermal comfort, wearability assessmentAbstract
Special-purpose garments require ergonomic verification because restricted mobility, unstable fit, localized pressure, and thermal discomfort can reduce task performance and wearer acceptance. This study evaluated a prototype through an ergonomic evaluation study involving 30 participants. Anthropometric measurements included height and body mass, while comfort was assessed through a structured point scale covering mobility, fit, pressure distribution, and thermal sensation. Taguchi signal-to-noise analysis and ANOVA were applied to compare comfort responses, and measurement uncertainty was estimated with a reproducible calculation formula. Twenty-two participants, representing 73.3 % of the sample, rated the clothing comfortable; six participants, or 20.0 %, reported moderate comfort, and two participants, or 6.7 %, found it uncomfortable. The mean garment comfort score was 4.1 points. Compared with the less favorable moderate and uncomfortable responses, the dominant comfortable rating indicates acceptable ergonomic performance, although pressure redistribution and seam placement remain important design variables. The contribution of the study is an integrated assessment scheme linking mobility, fit, pressure distribution, and thermal comfort within one garment-evaluation procedure.
References
1.ISO 8559-1:2017. Size designation of clothes — Part 1: Anthropometric definitions for body measurement. — Geneva: International Organization for Standardization, 2017.
2.ISO 8559-2:2025. Size designation of clothes — Part 2: Primary and secondary dimension indicators. — Geneva: International Organization for Standardization, 2025.
3.Ashdown S.P. Sizing in Clothing: Developing Effective Sizing Systems for Ready-to-Wear Clothing. — Cambridge: Woodhead Publishing, 2007. — 336 p.
4.ISO 20685-1:2018. Three-dimensional scanning methodologies for internationally compatible anthropometric databases — Part 1: Evaluation protocol for body dimensions extracted from 3-D body scans. — Geneva: International Organization for Standardization, 2018.
5.Song H.K., Ashdown S.P. Automatic body measurement for apparel using 3D body scan data // International Journal of Clothing Science and Technology. — 2011. — Vol. 23, № 5. — P. 314–330. — DOI: 10.1108/09556221111166208.
6.Simmons K.P., Istook C.L. Body measurement techniques: comparing 3D body-scanning and anthropometric methods for apparel applications // Journal of Fashion Marketing and Management. — 2003. — Vol. 7, № 3. — P. 306–332. — DOI: 10.1108/13612020310484852.
7.Kouchi M., Mochimaru M. Errors in landmarking and the evaluation of the accuracy of traditional and 3D anthropometry // Applied Ergonomics. — 2011. — Vol. 42, № 3. — P. 518–527. — DOI: 10.1016/j.apergo.2010.09.011.
8.Kouchi M., Mochimaru M. Anthropometric methods for computerized human modeling // Human Body Measurement and Modeling. — 2014. — Vol. 8529. — P. 1–11. — DOI: 10.1007/978-3-319-08530-5_1.




United Kingdom
Germany
France
Uzbekistan
Türkiye
Kazakhstan
Kyrgyzstan
Turkmenistan
Azerbaijan
India
Republic of Korea
Japan
United States of America
Kosovo
Italy
Spain
Poland
Netherlands
Belgium
Sweden
Norway
Finland
Denmark
Switzerland
Austria
Czech Republic
Hungary
Romania
Bulgaria
Greece
Portugal